Shopping Cart
It is important to get the best from your saw, especially if it has decent standard or upgraded fences. The UJK Aligning Jig is a moderately priced, highly accurate jig that is simple to use. On a table saw you can measure five items: Align the blade to the mitre slots Align the fence to the mitre slot, either parallel or with a measured amount of run-out at the end Check the axial run-out of the blade (the side to side wobble you see if the blade is turned slowly) Check the axial run out of the blade flange Check the axial run out of the blade arbor Based on a simple mounting bar that fits any 3/4" (19mm) mitre gauge slot, the mounting bar has adjustable spring loaded balls to ensure a snug fit, plus levelling screws to accommodate differing depths of mitre slot. The dial indicator reads in increments of 0.001" with a total travel of 1". Although primarily a circular saw tool you can also use it to set the blade heights on surface planers. An invaluable tool in any workshop.