10 radii covered in each setConcave for scraping spindles, chair legs etcConvex scrapers for recesses on skirting boards etcSharpen with a standard burnisherTwo scrapers per setScraper 1 - 1/4", 3/8", 1/2", 3/4" and 5/8"Scraper 2 - 7/8", 1", 1.1/8", 1.1/4" and 1.1/2"-bg
Made from high quality swedish chrome nickel steelCold rolled, hardened and tempered, with specially ground cutting edgesEach scraper comes complete with a plastic edge protectorIdeal for smoothing hardwoods, removing paint and varnish etc.Flat profile-bg
1/3 scale, fully functional cabinet scraperMeasures 97mm(3.13/16") wide overall, weight about 46gThumbscrew gives fine control over the amount of biteSpring steel blade 25mm wide, ground at 45° angleInvestment-cast steel with a stainless-steel camber screwSupplied in a French-fitted embossed leatherette box-bg
Smoothes glue lines or surfaces without tear-out, digs or gougesAllows pressure to be applied directly in line with the cutting edge70mm wide blade, with both cutting edges ground at 45°Shaped to protect the upward-facing cutting edgeSole is surface ground for accuracy (80 x 85mm)Made from ductile cast ironOverall length 290mm. Weighs about 740gMade in...
Hardened to HRC 48-52 to hold an edge longerEdges are carefully milled to a square, sharp 90°Prepared edges save time and effort of filing and stoningComes in set of four50 x 150 x 0.4 & 0.6mm for fine work60 x 150 x 0.8 & 1mm for heavier stock1mm scraper suitable for paint removal-bg
8 radii covered by this set of twoConcave for scraping quadrant mouldings etcConvex scrapers for recesses on skirting boards etcSharpen with a standard burnisherScraper 1 - 1/8", 3/16", 1/4" and 5/16"Scraper 2 - 3/8", 7/16", 1/2" and 5/8"-bg
Mini cabinet scraper setMini gooseneck - good for concave areasMini oval - also good for curved areasMini square - good for a variety of straight edges plus notches for luthier workMini concave/convex - good for curved areas and also luthier work-bg
Used to produce a precise even finishIdeal when used to smooth difficult grain on large areasAdjusting nut varies the bite of the bladeFine grey iron casting with machined base70mm(2-3/4") wide blade-bg
Accepts 140mm to 150mm long scraper bladesGlass reinforced nylon bodyClamps either side allow for projection adjustmentCentral knurled knob controls amount of bowIncludes a Veritas milled edge scraper-bg
Hardened to HRC 48-52 to hold an edge longerEdges are carefully milled to a square, sharp 90°Prepared edges save time and effort of filing and stoningComes in set of four50 x 150 x 0.4 & 0.6mm for fine work60 x 150 x 0.8 & 1mm for heavier stock1mm scraper suitable for paint removalMakes raising a burr an easy jobCarbide rods fixed at an angle in...