Внимание: Последни налични продукти
Очакваме доставка на:
You take advantage of the precise grid layout of the Festool MFT/3 table top for fast and repeatable work positioning, and are particularly useful for accurately aligning work in relation to the guide rail for 90° or 45° cuts. CNC machined from aluminium, they have a flat face for work registration and a rim that supports and stabilises them on the bench surface. Each dog has a post that fits into the 20mm holes of the Festool MFT/3 table top. They are supported on the surface of the bench by a thicker boss or collar, 25mm in diameter and 10mm high, which provides a good bearing surface and stability in use. For additional security, each dog has a threaded hole to fasten it from below the table with a suitable clamping knob available separately. The two sizes of dog can be used for a variety of different purposes. Apart from their use as a low-profile stop, the dogs can be inverted and inserted from below the table top to exploit the M8 threaded through hole as an anchor point. If you don't own a Festool table then a DIY cutting table can be produced using some 19mm MDF with a few 20mm holes bored at the required positions for 90° or 45° cuts.